2: Evaluation Kit
xPico® Wi-Fi® Embedded Device Server Evaluation Kit User Guide
17
Table 2-12 JP6 LED Header Connections (XPW100100K-01 and XPCW1002100K)
Jumper Position
Description
Pins 1 to 2
Install to connect module Ethernet link/WLAN status signal to LED2
Pins 3 to 4
Install to connect module Ethernet Speed signal to LED3
Pins 5 to 6
Install to connect module Ethernet Activity signal to LED4
Pins 7 to 8
Install to connect module Ethernet Duplex signal to LED5.
Remove when using xPico Wi-Fi module to prevent conflict with module wake up
signal.
This jumper is not stuffed by default.
Table 2-13 JP6 LED Header Connections (XPW100300K)
Jumper Position
Description
Pins 1 to 2
Install to connect module WLAN status signal to LED2
Additional Headers
The table below lists the pin functionality of the additional evaluation board headers.
Table 2-14 Additional Headers
J1 Pin
Header Pin
Signal
Function
36
JP3 pin 1
Module reset to defaults
(active low)
Install jumper (JP3 pins 1 to 2) to use SW1
for asserting default function.
38
JP4 pin 1
Module hardware reset
(active low)
Install jumper (JP4 pins 1 to 2) to use SW2
for asserting hardware reset.
14
JP16 pin 1
Module wake up (rising edge
triggered)
Install jumper (JP16 pins 1 to 2) to use SW4
for asserting module wake up.
Do not install when using xPico (wired)
Ethernet Duplex LED signal.
35
JP5 pin 1
CP1, configurable pin
Test point
26
JP5 pin 2
CP2, configurable pin
Test point
28
JP5 pin 3
CP3, configurable pin
Test point
30
JP5 pin 4
CP4, configurable pin
Test point
32
JP5 pin 5
CP5, configurable pin
Test point
34
JP5 pin 6
CP6, configurable pin
Test point
27
JP5 pin 7
CP7, configurable pin
Test point
3
JP5 pin 8
CP8, configurable pin
Test point
