Lantronix
ION x6010 User Guide
33493 Rev. F
Page 34 of 261
Installing SFPs
Some models allow you to install a Small Form-Factor Pluggable (SFP) device of your choice in order to
make a fiber connection. The x61x0-1040 models have a single SFP port. The x61xx-x040 models have
two SFP ports. See the SFP manual for cautions and warnings.
Figure 17: SFP Installation
1.
Position the SFP device at either installation slot, with the label facing up (on the S6010) or to the
right (on the C6010).
2.
Carefully slide the SFP device into the slot, aligning it with the internal installation guides.
3.
Ensure that the SFP device is firmly seated against the internal mating connector.
4.
Connect the fiber cable to the fiber port connector of the SFP device.
Note
: Make sure the SFP release latch is in the up (closed) position when you insert the cable connector
into the SFP at the fiber port. (There should be a slight ‘click’ when connected.)
Connecting the C6010 to the S6010
Connect the C6010 to the S6010 using fiber ports. If two fiber lines are supported, connect the local and
remote device’s primary lines together, and then connect the secondary lines together.
