6: Configuration via Serial Mode or Telnet Port
WiPort Embedded Wireless Device Server User Guide
74
key length, 48 characters for 192 bits key length, or 64 characters
for 256 bits key length.
Enable Enhanced Password
The Enhanced Password setting allows you to set a password of up to 16 characters
for protecting Telnet and Web Page access. We recommend that you select the
Y
(Yes) option and enable the enhanced password setting.
Avoid using either the 4 character basic password setting or no password at all as
they are not secure options.
Enable Enhanced Password (Y) ? _
Disable Port 77F0 (Hex)
Port 77F0 allows a custom application to query or set the eleven WiPort configurable
pins when they are functioning as general purpose I/O (GPIO). Disable this
capability, if desired, for security purposes.
Disable Port 77F0h ? _
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.
Default Settings (Option 7)
Select
7 Defaults
from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, netmask, wireless enable, infrastructure or ad hoc setting, and wireless
security settings remain unchanged. The configurable pins’ settings also remain
unchanged. The specific settings this option changes are listed below.
Note:
To reset network settings to factory defaults, use one of the “Reset to
Defaults” Configurable Pin Settings. For more information on Configurable
Pins, see
on page
Channel 1 Configuration
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C, no flow
control)
Port No
10001
Connect Mode
C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter
3
Hostlist Retry Timeout
250 (msec)
Send Character
0x0D (CR)
All other parameters
0
