3. Respond to the installation wizard prompts. (If prompted to select an installation type,
select Typical.)
Note:
For more information about DeviceInstaller, see the
Assign IP
The unit’s IP address is normally set for DHCP at the factory. The hardware address is
on the product label. The unit is DHCP enabled as the default. Change the IP address if
you do not want the network to automatically assign an IP address to the WiPort.
1. Click
Start
Programs
Lantronix
DeviceInstaller
DeviceInstaller.
If your PC
has more than one network adapter, a message displays. Select an adapter and click
OK
.
Note:
If the unit already has an IP address (e.g., DHCP has assigned an IP
address), click the Search icon and select the unit from the list of Lantronix
device servers on the local network.
2. Click the
Assign IP
icon
.
3. If prompted, enter the hardware address (on the product label) in the format 00-20-
4a-XX-XX-XX, where the XXs are unique numbers assigned to the product. Click
Next
.
4. Select
Assign a specific IP address
and click
Next
.
5. Enter the
IP address
. The
Subnet mask
displays automatically based on the IP
address; if desired, you may change it. On a local network, you can leave the
Default
gateway
blank (all zeros). Click
Next
.
WiPort Evaluation Kit Quick Start Guide
5
