Lantronix
SI-IES-1x1D-LRT User Guide
33585 Rev. L
Page
13
of
25
Wiring the Power Inputs
Follow the steps below to insert the power wire.
1. Locate the labeling on the device indicating the location of V+ and V- power input connections
on the device.
2. Insert the positive and negative wires into the V+ and V- contacts on the terminal block
connector.
3. Tighten the wire-clamp screws on the terminal block, highlighted in red above, to secure the
wire connections.
Note
: The wire gauge for the terminal block should be 12~ 24 AWG.
Note
: Adjust the power supply as required. These devices accept 48~57VDC; higher voltage
(50~57VDC) may be required for some high powered PD loads.
