Lantronix SecureLinx SLK Series, User Manual

Page: 89 / 160

Using the Web Control Interface to Configure the SLK
SecureLinx SLK Remote KVM User Guide 4-43
Configuring SNMP
The Simple Network Management Protocol (SNMP) is the most widely used way to
gather information about the status of individual nodes on the network and make
changes in the operational parameters of the nodes. The
SNMP link lets you control
the SNMP settings for the SLK.
Note: If you are not familiar with using SNMP, do not change the settings on
this page.
Figure 4-27. SNMP Configuration Page
System Variables
This area lets you specify the location where the SLK resides, a system contact,
and a system name.
Community Names
This area lets you define the read and write community name to be used.
Trap Send Enable
This area lets you enable or disable SNMP notifications and authentication traps.
Trap Destination
This area lets you specify a target IP trap address and a target IP trap port.