Lantronix
SDSTX3110-124-LRT-B User Guide
33686 Rev. C
21
4.1.3 Using SDS-Manager
Screen Elements
File
File
>
New SDS-Manager
:
File
>
Load SDS-Manager
: at the dialog box, select a file to load and click Open.
File
>
Save SDS-Manager
: at the dialog box, select a file to load and click Save.
File
>
Virtual COM Wizard
: brings you to setup the device serial port(s) and map it to
Virtual COM as follows:
STEP 1. Select serial port(s) from available devices.
STEP 2. Setup these serial ports(s), baudrate, data bits...etc.
STEP 3. Select the Virtual COM(s) naming.
STEP 4. Done.
File
>
Serial Tunnel Wizard
: helps you couple two serial devices to directly
communicate by Ethernet without the PC:
STEP 1. Select two devices that should be tunneled together.
STEP 2. Select serial parameters such as baud rate, data bits.
STEP 3. Finish.
File
>
Group IP Wizard
: helps you configure the IP addresses of a group of new
devices. The devices already in the configuration list will not be included.
STEP 1. Locate the new devices by broadcast or by IP range.
STEP 2. Configure the IP range or DHCP IP.
STEP 3. Start.
File
>
Group Setup Wizard
: helps you copy one device settings to the other same models:
STEP 1. Select the device model.
STEP 2. Select the source device and the destination devices.
STEP 3. Select the device and port settings to copy.
STEP 4. Start copying.
