5: Commands and Levels
PremierWave® 2050 Enterprise Wi-Fi® IoT Module Command Reference
360
state enable
Enables the line so data can be sent/received.
stop bits 1
Uses one stop bit after data on the line.
stop bits 2
Uses two stop bits after data on the line.
terminal
<line>
Enters the configure-terminal level. <line> = number of the
terminal line (serial port) to be configured.
terminal network
Enters the configure-terminal level for the network.
termination disable
Refrains from terminating the line.
termination enable
Enables 120 ohm line termination in RS485 half-duplex
mode.
threshold
<bytes>
Sets the threshold in bytes. After this many bytes are re-
ceived, they are forwarded without delay.
tunnel
<line>
Enters the tunnel level. <line> = number of the tunnel line
(serial port) to be configured.
usb
<line>
Enters the usb level. <line> = number of the line (usb port)
to be configured.
write
Stores the current configuration in permanent memory.
xoff char
<control>
Sets the xoff character for use with software flow control
on this line. The character may be input as text, control,
decimal, or hex. A control character has the form <con-
trol>C. A decimal value character has the form \99. A hex
value character has the form 0xFF.
xon char
<control>
Sets the xon character for use with software flow control
on this line. The character may be input as text, control,
decimal, or hex. A control character has the form <con-
trol>C. A decimal value character has the form \99. A hex
value character has the form 0xFF.
line 1 (config-mach10-line:1) level commands
clrscrn
Clears the screen.
command delimiter
<text>
Sets the command delimiter.
content check interval
<hours>
Sets the firmware and configuration check interval.
default command delimiter
Restores the command delimiter.
default content check interval
Restores the default firmware and configuration check
interval.
default local port
Clears the local port for Mach10 client.
default status update interval
Restores the default status update interval.
exit
Exits to the config-mach10 level.
line
<number>
Change to line configuration level.
local port
<number>
Sets the local port for Mach10 client. When configured, a
total of 16 consecutive ports will be reserved.
no project tag
Restores the default Project Tag.
project tag
<text>
Sets the Project Tag.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
state disable
Disables command processing on line.
state enable
Enables command processing on line.
status update interval
<minutes>
Sets the status update interval.
write
Stores the current configuration in permanent memory.
