Open-Q 212A Development Kit
Open-Q™ 212A Development Kit User Guide
17
For details on how the Wi-Fi module connects to the on-board PCB antennas on the carrier board, refer to
section
Error! Reference source not found.
.
3.7.1 SOM RF Interface for GNSS Antenna
The SOM includes one U.FL type coaxial connector for the GNSS receiver antenna, with a +2.7v bias on it to
provide power for an active GNSS antenna. By default, this port is connected to the carrier board PCB antenna
labelled “GPS” via a coaxial cable. If desired, a suitable GNSS antenna with a U.FL connector could be
connected directly to the SOM antenna port by carefully removing the carrier board coaxial cable.
For more information about connecting a GPS antenna to the development kit see section 3.8.15
Error!
Reference source not found.
below.
Note that the GNSS receiver may not be supported by all SW versions. Please refer to the latest SW Release
Notes document to confirm support.
