Lantronix
ION219-x Install Guide
33412 Rev. E
19
Grounding Path
The electrical conducting path from the chassis to ground must:
•
Flow via the grounding lugs to the Common Bonding Network (CBN) for telecom installations, or to an
alternate approved grounding system (if required) for non-telecom installations.
•
Be sufficiently low in impedance to conduct fault currents likely to be present on the chassis.
•
Enable proper operation of any over-current protection devices.
Fasten the two-hole compression-type grounding connector to the grounding lugs with the provided Kepsnut
fasteners. See Figure 9 below.
Figure 9: Chassis Grounding Hardware
