3: Open-Q 865XR SOM Development Kit
Open-Q 865XR SOM Development Kit User Guide
30
3.7.15
Camera option Connectors J1001 (18), J1101 (19), J1201(20)
In addition to the three camera connectors, the video capturing subsystem of the Open-Q 865XR SOM
Development Kit is equipped with three connectors for camera optional signals (J1001, J1101 and
J1201). The option connector pins are NOT connected anywhere else on the CB and is expected to be
connected via wires to other GPIO headers on the dev kit if desired to be used by the dev kit user.
See items 18, 19 and 20 in Figure 1 for the carrier board locations of the camera option connectors. The
pinout of the connectors in shown in the table below.
Table 12. Camera option Connectors pinout
Pin No
Signal Name
Description
1
CAM_FRAME_SYNC
Camera connector pin 12 frame sync,
need wires to other
GPIO header
2
CAM_FLASH_TRIG
Camera connector pin 18 flash trigger,
need wires to
other GPIO header
3
CAM_IRQ
Camera connector pin 37 interrupt request,
need wires to
other GPIO header
4
GND
System Ground
3.7.16
M.2 PCIe Card Connector J2700 (24)
The Open-Q 865XR SOM Development Kit includes a M.2 PCIe socket with a B-Key ID J2700 (24) and
an optional SIM card socket J2701 (25) on the bottom side of the carrier board (see image below).