10: Device Ports
EMG™ Edge Management Gateway User Guide
186
Telnet/SSH/TCP in Port Numbers
Caution:
Ports 1-1024 are RFC-assigned and may conflict with services running
on the EMG. Avoid this range.
2. Click the
Apply
button to save the settings.
To configure a specific port:
1. You have two options:
-
Select the port from the ports list and click the
Configure
button. The
-
Click the port number on the green bar at the top of each page.
2. Continue with directions in the section,
Device Ports - Settings (on page 187)
Device Port Global Commands
Go to
to view CLI commands which correspond to the web page entries
described above.
Starting Telnet Port
Each port is assigned a number for connecting via Telnet. Enter a number (1025-
65528) that represents the first port. The default is 2000 plus the port number. For
example, if you enter 2001, port 1 will be 2001 and subsequent 2000 ports are
automatically assigned numbers 2001, 2002, and so on.
Starting SSH Port
Each port is assigned a number for connecting via SSH. Enter a number (1025-
65528) that represents the first port. The default is 3000 plus the port number. For
example, if you enter 3001, port 1 will be 3001 and subsequent 3000 ports are
automatically assigned numbers 3001, 3002, and so on.
Starting TCP Port
Each port is assigned a number for connecting through a raw TCP connection. Enter
a number (1025-65528) that represents the first port. The default is 4000 plus the
port number. For example, if you enter 4001, port 1 will be 4001 and subsequent
4000 ports are automatically assigned numbers 4001, 4002, and so on.
You can use a raw TCP connection in situations where a TCP/IP connection is to
communicate with a serial device. For example, you can connect a serial printer to a
device port and use a raw TCP connection to send print jobs to the printer over the
network.
Note:
When using raw TCP connections to transmit binary data, or where the break
command (escape sequence) is not required, set the Break Sequence of the
respective device port to null (clear it).
Summary of Contents for EMG 7500
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings ...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG ...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity ...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued ...
