7: Networking
EMG™ Edge Management Gateway User Guide
115
Routing
The EMG allows you to define static routes and, for networks using Routing Information Protocol
(RIP)-capable routes, to enable the RIP protocol to configure the routes dynamically.
To configure routing settings:
1. Click the
Network
tab and select the
Routing
option. The following page displays:
Figure 7-10 Network > Routing
2. Enter the following:
Dynamic Routing
Static Routing
3. Click the
Apply
button.
Enable RIP
Select to enable
Dynamic Routing Information Protocol (RIP)
to assign routes
automatically. Disabled by default.
RIP Version
Select the
RIP
version. The default is
2
.
Enable Static
Routing
Select to assign the routes manually. The system administrator usually provides the
routes. Disabled by default.
To add a static route, enter the
IP Address
,
Subnet Mask
, and
Gateway
for the
route and click the
Add/Edit Route
button. The route displays in the Static Routes
table. You can add up to 64 static routes.
To edit a static route, select the radio button to the right of the route, change the
IP
Address
,
Subnet Mask
, and
Gateway
fields as desired, and click the
Add/Edit
Route
button.
To delete a static route, select the radio button to the right of the route and click the
Delete Route
button.
Summary of Contents for EMG 7500
Page 100: ...7 Networking EMG Edge Management Gateway User Guide 100 Figure 7 5 Network Wireless Settings ...
Page 353: ...15 Maintenance EMG Edge Management Gateway User Guide 353 Figure 15 12 About EMG ...
Page 474: ...EMG Edge Management Gateway User Guide 474 Figure E 3 EU Declaration of Conformity ...
Page 475: ...EMG Edge Management Gateway User Guide 475 Figure E 4 EU Declaration of Conformity continued ...
