Hardware Interfaces
BOLERO40 Series Hardware Manual
32
$PFAL,IO
13
.Set=cyclic,2000,1000
RED
13
Turns on the LED in a cyclic
manner.
To turn off these LEDs, use the following command with corresponding index number:
PFAL COMMANDS
LED COLOR LED INDEX DESCRIPTION
$PFAL,IO
12
.Set=low
GREEN
12
Turns off the LED
$PFAL,IO
13
.Set=low
RED
13
Turns off the LED
6.4
Mounting
When installing BOLERO45, please make sure the device's top side with the text "THIS SIDE
TO THE SKY" is facing up and in full view of the sky and that no metal objects is interfering
GNSS/GSM signals. Try to operate with the device with permanently powered by car battery
instead of its backup battery. The device should be configured to automatically switch from
main power to battery backup when main power is not available and visa-versa when main
power is available again.
Each of BOLERO40 provides 4 holes for attaching it to suitable locations (see figure below).
It can be mounted in different locations such as on wall or in vehicle. There are two types
of mounting options either with using your own double-sided adhesive pad (not included)
or cable ties (not included). For more detailed information how to install BOLERO40 devices
in the vehicle and what should be considered during the installation, refer to the application
note [
AppNotes_AVL_Installation_Guide.pdf
].
Figure 11
: Device mounting types
