Lantronix 100-120 VAC SLB, User Manual, Page: 69 / 344

6: Basic Parameters
SLB™ Branch Office Manager User Guide 69
Updating an IP Filter
To update an IP filter rule set:
1. From the Network > IP Filter page, the administrator selects the IP filter ruleset to be edited
and clicks the Edit Ruleset button to return to the Network > IP Filter Ruleset (Adding/Editing
Rulesets) page (see Figure 6-4 ).
2. Edit the information as desired and click the Apply button.
Deleting an IP Filter
To delete an IP filter rule set:
1. On the Network > IP Filter page, the administrator selects the IP filter ruleset to be deleted and
clicks the Delete Ruleset button.
Mapping a Ruleset
The administrator can assign an IP Filter Ruleset to a network interface (Ethernet interface) and a
modem connected to a Device Port.
To map a rule set to a network interface:
1. On the Network > IP Filter page, select the IP filter ruleset to be mapped.
2. From the Interface drop-down list, select the interface and click the Map Ruleset button. The
Interface and rule set display in the IP Filter Mappings table.
To delete a mapping:
1) On the
Network > IP Filter
page, select the mapping from the list and click the Delete
Mapping button. The mapping no longer displays.
2) Click the Apply button.
IP Filter Commands
Go to IP Filter Commands (on page 303) to view CLI commands which correspond to the web
page entries described above
Routing
The SLB branch office manager allows you to define static routes and, for networks using Routing
Information Protocol (RIP)-capable routes, to enable the RIP protocol to configure the routes
dynamically.
To configure routing settings:
1. Click the Network tab and select the Routing option. The following page displays: