Lantech IPWMR-3004, User Manual

Page: 11 / 26

7
1.4. LED Indicators
The diagnostic LEDs that provide real-time information of system and optional status are
located on the front panel of the industrial switch. The following table provides the
description of the LED status and their meanings for the switch.
LED Color Status Meaning
PWR1 Green
On Power 1 is active
Off Power 1 is inactive
PWR2 Green
On Power 2 is active
Off Power 2 is inactive
Fault
Red
On Power or port failure
Off No failure
LTE Green
On LTE is active
Off LTE is inactive
WLAN Green
On WLAN is active
Off WLAN is inactive
GPS
Green
On GPS OK
Blinking Searching GPS Signal
Ready Green On Power is on and functioning normally.
P1 ~ P6
LNK/ACT
Green
On A network device is detected.
Blinking
The port is transmitting or receiving packets
from the TX device.
Off No device attached
P1 ~ P6
Speed
Yellow
On The port is operating in 1000T mode.
Off
The port is operating in 10/100TX mode.