Lanner NVA-3000 Series, User Manual

Page: 47 / 54

Chapter 4: Hardware Setup
47
To reduce the risk of personal injury, electric shock, or damage to the equipment, please remove all power
connections to completely shut down the device. Also, please wear ESD protection gloves when conducting
the steps described hereafter.
In light of the motherboard layout arrangement, the installation of the M.2 card, DDR4 memory, and
Wireless module should be prior to that of the 3.5” hard disk.
1. Loosen the TWO screws (indicated in the photos) that fix this unit’s top cover and the rear panel.
2. Pull the top cover panel open horizontally, and then lift to remove it.