Lanner LEC-2290H, User Manual

Page: 100 / 107

LEC-2290H User Manual
100
You can configure the value of voltage, power on delay, DI/DO and others on LEC-2290 via the MCU command
line. Below are the requirements to enable the command line
1. Host communication interface: COM#7 (RS-232)
2. Support baud rate: 57600/ 8N1
3. Communication protocol: ANSI terminal.
Use below formula to set/get your command line:
GET VariableName
SET VariableName value
MCU Command Write/Read
(SET/GET)
VariableName value
Startup Voltage(mV)
SET STARTUP_VOLTAGE 0(default) 0mV
GET STARTUP_VOLTAGE
Shutdown
Voltage(mV)
SET INPUT_VOLTAGE_MIN 8500(default) 8500mV
GET INPUT_VOLTAGE_MIN
PowerOn Delay (Sec)
SET POWERON_DELAY 4(default) 4S
GET POWERON_DELAY
PowerOff Delay (Sec)
SET SHUTDOWN_DELAY 4(default) 4S
GET SHUTDOWN_DELAY
Input Voltage GET INPUT_VOLTAGE
Device ID GET DEVICE_ID LEC-2290_N
Firmware Version GET VERSION 0.07B
Ignition GET IGNITION
Digital POE
SET DIGITAL_POE 15(default) 0~15
GET DIGITAL_POE
Digital DO SET DIGITAL_DO 0(default) 0~255
Digital DI GET DIGITAL_DI
Save flash SAVE