HLM-1101 User Manual
14
To access some components and perform certain service procedures, you must perform the following
procedures first.
Warning
: To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
the power cord to remove power from the server. The front panel Power ON/Standby button does
not completely shut off system power. Portions of the power supply and some internal circuitry
remain active until AC power is removed.
The HTCA-6000 series is a system that provides two to six externally accessible LAN I/O blades, and/or
switch blades, varies depending on ordered configurations. Please follow the steps below to access the
switch blades.
1.
Select a switch blade you wish to access. Pull the two lever locks inwards.
2.
Then, rotate and loosen the captive screws above the lever locks.
3.
Hold on to the two lever locks on each side and push outwards to gently pull out the switch blade.
4.
Repeat the steps to insert a new switch blade.
