Lanier 5455, Operator'S Manual

Page: 10 / 184

1
Important Safeguards
Always follow these important safeguards:
1
Read all of these instructions before using the unit.
2
Plug the power cord into a 3-conductor
(grounded) outlet. Check the Specifications
chapter to make sure the outlet meets the ampere
rating of this unit.
•
Never ground the power cord to a gas pipe or
a water pipe.
•
Keep the power cord away from hot surfaces.
•
Avoid using an extension cord if possible.
•
If you must use an extension cord, use only a
3-conductor cord rated for the ampere rating
of your unit. Refer to the Specifications
Chapter for this value. Power cords rated for less can overheat and become a fire hazard.
3
Do not operate the unit if any part of it is damaged, or if any part has been dropped, until it
is checked by a authorized Lanier Service Technician.
4
The fusing area is hot. Exercise care in this area.
5
Do not install the unit in areas that are:
•
Damp or humid
•
Exposed to direct sunlight
•
Extremely dusty
•
Poorly ventilated
•
Close to machines generating ammonia such as diazo copy machines.
•
Subject to extreme temperature or humidity changes, for example, near an air
conditioner or heater
6
Place the unit on a firm, level surface.
7
For proper ventilation and cooling, keep the unit at least 4 inches back from the wall and
allow 32 inches of clearance on the left and right sides of the copier. If the optional sorter is
used, allow 48 inches on the left side of the copier.
Agency Certifications
Your unit complies with FCC rules, DOC requirements, and other agency certification
requirements. Refer to the Specifications chapter of this Operator Guide for further details.