Lanier 5222, Operator'S Manual

Page: 17 / 102

Configuring Windows 95/98
Windows 95/98 Configuration 2 - 3
Preparing to Use the NetBEUI Protocol for Printing
Configuring the Printer
Configure your printer to use the NetBEUI protocol.
•
Confirm that the NetBEUI protocol is set to be active. (The factory default is active.)
For more information on how to make the above settings, refer to the Operator Guide for your
printer.
Configuring a Windows 95/98 Computer
Install the NetBEUI protocol into a Windows 95/98 computer, and configure NetBEUI as the
default protocol.
1
Double-click the [Network] icon in the [Control Panel], and confirm that “NetBEUI” is in
the [The following network components are installed] list of [Configuration] tab.
•
If NetBEUI is not installed, click [Add] of [Configuration] tab, and install it.
2
Configure the NetBEUI protocol as the default protocol. Click the [Configuration] tab,
select “NetBEUI” in the [The following network components are installed] list, and click
[Properties]
3
Click the [Advanced] tab, select [Set this protocol to be the default protocol], and click
[OK].
4
Click [OK] to close the [Network] dialog.
5
After confirming the message to restart, click [Yes]
.
To use the NetBEUI protocol to print, the network must be configured as described below.