11
7.5
Aligning crossing symbol
The pedestrian signal requesting device
is factory-fitted with a crossing symbol
(1)
.
If the specified direction of the crossing
symbol does not match the direction
required, proceed as follows:
Fig. 12
•
Insert the special key
(1)
behind the
crossing symbol and press down.
•
The brackets
(2)
are opened.
Fig. 13
•
Press the crossing symbol
(2)
in
slightly and click it out of place.
•
Turn the crossing symbol into the
required direction.
Note:
The fitted spring must not fall
out!
•
Remove the special key
(1)
.
•
Release the crossing symbol and click
it back into place.
Note:
Check the built-in seal for
correct fit.
Fig. 14
1
1
2
2
1
