- 53 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Fastening the Device Under Test
16
Fastening a Device Under Test With the Clamping Pieces
16.1
Fasten the clamping pieces with the hexagon socket screws M6 (hexagon socket 5 mm) and the
T-nuts in the selected T-slots.
The clamping pieces' angle and height can be changed with the grub screws M8 (hexagon socket
4 mm).
Note: Scratches and/or other traces may be left on the T-slot table if the clamping pieces are
fastened too tight, fasten the screw only hand-tight.
Process:
Insert the first T-nut into the desired T-slot and move to the desired position.
Figure 59: Inserting the T-nut into the T-slot
Then place the clamping piece above the T-nut and secure loosely with the hexagon socket
screw M6.
Figure 60: Fastening the clamping piece with the
hexagon socket screw on the T-slot plate
Figure 61: Adjusting the height and angle of the clamping
piece with the grub screws
