- 36 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
Preparations for Putting the FLS 106 Scanner into
12
Service
Preparations for the Safe Operation of the FLS 106 Scanner
12.1
There are two options to ensure the system's safe operation: use the SUH 106 safety enclosure or
provide for a spatial separation (see Section 6.1).
When choosing the place of installation, consider which of the aforementioned safety solutions is to
be implemented.
Setting Up the FLS 106 Scanner
12.2
Only remove the protective film after setting up the FLS 106 scanner at its place of installation.
The scanner dimensions are 1,030 x 775 x 990 mm and its weight is 75 kg.
There is thus an increased risk of injuries when carrying or moving the scanner.
Do not carry or move the scanner alone.
The FLS 106 scanner may only be used in closed rooms under appropriate light conditions.
Take the space requirements for cordoning off the area into account if you intend to operate the
system with a spatial separation.
The scanner should be installed on a raised surface such as a table, workbench, etc. Check the
worktop's size and load-bearing capacity before installing the system.
Ensure that the worktop is large enough and its load-bearing capacity is not exceeded (total weight
including the SUH 106 approx. 125 kg) if you intend to operate the system with the SUH 106 safety
enclosure.
Make sure that the free working area around the scanner is large enough for the scanner to be
handled properly.
The scanner should be set up on a level, firm and clean surface. Secure the
scanner against slipping and falling down if there is a risk of it slipping. There is
an increased risk of injuries due to the scanner's high weight.
After setting up the scanner at its place of installation, remove the protective film by hand. Do not
use any tools such as knives, cutters or scissors to remove the protective film. There is a risk that
sharp-edged, metallic tools cause damage to the system, such as scratches on the scanner or
damage to the insulation of cables or to persons by cuts.
