Retrofit kit for dial indicator test devices
ed. 01/2017
page 6
4
Safety instructions
The
QMSOFT® retrofit kit
is in compliance with the relevant safety provisions and has been assembled
and packed with care. Nevertheless, please observe the following safety instructions:
Before connecting and starting the retrofit kit, please read all the enclosed documents carefully.
Keep this manual close to the point of use of the retrofit kit, in order to have it handy in case of
need.
The retrofit kit must only be used in accordance with its intended use for the measuring tasks
described in this manual. Any different or further use is considered to be improper use. L&W
GmbH shall not be liable for any damage resulting from improper use. The proper and intended
use also includes the observation of all the safety instructions of this manual.
Before connecting the power supply of the lighting unit, please check if the supply voltage
indicated on the type plate of the plug-in power supply corresponds with the local voltage.
Should they not correspond, do not connect the power supply!
Always disconnect the power supply of the lighting unit before starting any maintenance works on
the lighting unit.
Assembly works on the retrofit kit must only be carried out by trained service personnel.
Unauthorized interventions or modifications of the retrofit kit result in exclusion of warranty and
exclusion of liability of L&W GmbH.
The retrofit kit is not protected against the penetration of liquids. Please avoid any contact of the
kit – in particular of the camera and the lighting unit - with liquids!
All the connections and power supply cables must be checked to be in proper operating condition
(visual inspection) prior to their use. In case of damages, the cables have to be changed
immediately by trained personnel.
Should you have any further questions, please contact your supplier or L&W GmbH.
