landskap AMIATA Vital +, Installation Instructions And User Manual

Page: 96 / 101

96 (101)
ENG
Flow-related checks
Check whether the water level is low, whether something is blocking the inlet flow, whether the valves are shut, whether there are any
air pockets, whether too many jet nozzles are closed, and whether the pump has been primed. Even when the spa has been switched
off, certain systems can activate certain equipment to monitor the temperature or activate freeze protection.
*This message can be reset by pressing any button on the panel on the top.
SENSOR-RELATED MESSAGES
OTHER MESSAGES
*This message can be reset by pressing any button on the panel on the top.
Poor sensor balance – M015
The temperature sensors MAY be out of sync by a few
degrees. Call for service.
Poor sensor balance* – M026
The temperature sensors ARE out of sync. A poor sensor
balance has been detected for at least an hour. Call for
service.
Sensor fault – Sensor A: M031, Sensor B: M032
A temperature sensor or sensor circuit is broken. Call for
service.
No communication
The control panel is receiving no communication from the
system.
Call for service.
Pre-production software
The control system is running using test software. Call for
service.
°F or °C are replaced by °T
The control system is running in test mode. Call for service.