Landoll Weatherproofer III 2310 Series, Operator'S Manual

Page: 67 / 80

OPERATION AND MAINTENANCE
4-11
Disc Gang Angle Settings
1. Under normal operating conditions, the gang angles
may be set front at 18
o
, rear at 16
o
or front at 14
o
,
rear at 12
o
(See Figure 4-10.) The more aggressive
angles, front at 18
o
, rear at 16
o
, will tend to bury more
residue than the less aggressive settings. With either
combination, the gang depth can also be adjusted to
operator preferences of levelness and residue
coverage.
2. In certain conditions it is possible to use different
combinations of the gang angles, but is not
recommended.
3. For most conditions the rear gang depth should be
the same or shallower than the front gang. To adjust
rear gang depth, extend radius rod to increase depth
or retract radius rod to decrease depth.
IMPORTANT
After adjustments are made to rear gangs, check
both sides to be sure they are the same depth. this
can be done by measuring from the frame down to
the top of the blades of each gang.
4. The front gangs should not require any adjustment of
the radius rods after they are initially set (See
Figure 4-10.)