Landoll Brillion SSP4, Operator'S Manual

Page: 15 / 34

ASSEMBLY OF OPTIONAL EQUIPMENT
2-5
5. At the rear of the seeder, mount the L-shaped
bracket to the end plate with a 5/8-11 x 1-1/2” bolt
and locknut as shown.
See Figure 2-5. The small
shoulder on the bracket should butt up against the
end plate of the seeder frame. On top of this bracket
mount the pickup with two #8-32 x 1-1/4” bolts, flat
washers, lockwashers, and nuts.
6. Extend its longer wire up toward the side of the
seedbox to meet the wire from the acre meter. Attach
its shorter wire to the ground on the bracket.
(Remove paint under the terminal to assure a good
electrical connection.)
7. Press the magnet wheel firmly onto the shaft.
IMPORTANT
There should be a gap of 1/8” between the pickup
and the magnet wheel.
8. Plug the acre meter cable into the pick-up box cable.
Figure 2-5: Acre Meter Rear Installation (2 of 2)
/RFNZDVKHU
*URXQG
:LUH
%ROW
;´
/RFNZDVKHU´
6WRYHU1XW´
%UDFNHW
0DJQHW
:KHHO
5HDU2I
6HHGHU
3LFNXS
1XW
%ROW
;´
1XW
´*DS
3LFNXS%R[
&DEOH
%ROW
;´
)ODW:DVKHU