MAINTENANCE
F-851R0
4-7
Clamp End Spacers - Optional
The Clamp End Spacer Kits are used to eliminate space
between the Axle Clamp and the Wheel Stop.
IMPORTANT
Unfold and lower machine prior to performing any steps.
Kit Part Number 201442 - 3/4” Axle Spacer
Kit Part Number 201443 - 1/2” Axle Spacer
Installation is the same for either kit.
1.
Place the two Axle Spacers between the Axle Clamp
and the Wheel Stop.
2.
Insert two 3/8-16 x 1-3/4 Bolts through the Axle
Spacers and secure with 3/8-16 Locknuts.
3.
Refer to the Torque Table for proper bolt torque
values. Note the different torque requirement for
Bolts with Locknuts.
See
Figure 4-6: Clamp End Spacer Kit 1 of 2 - Optional
&ODPS(QG6SDFHU.L
$[OH6SDFHU´
%ROW
[
/RFNQXW
$[OH6SDFHU´
/RFNQXW
$[OH6SDFHU´
%ROW
[
$[OH6SDFHU´
$[OH
&ODPS
:KHHO6WRS
Summary of Contents for Brillion PC
