Landoll Brillion Alfalfa SS108, Operator'S Manual

Page: 17 / 92

9K713-0522 2-1
TABLE OF CONTENTS
Chapter 2
Assembly
CAUTION
WARNING
NOTE
Refer to the repair parts manual 9K712 for identification of
parts and for the approximate relationship of the parts in
assembly.
To ensure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use Lock Washers or
Flat Washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion or binding. Tighten all
screws and nuts to the recommended torques.
IMPORTANT
• If a pre-assembled parts or fastener is temporarily
removed, remember where they go. It is best to keep
parts separated.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
• Park the seeder in a work area that has a level
surface and make sure it is blocked securely so that
it cannot roll.
• Refer to the Torque Table for proper torque valves.
Note the different torque requirements for Bolts with
Locknuts.
See Page 5-1.
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
IMPORTANT
All harnesses must be firmly attached to machine
frame members, so they don’t sag or become torn
loose by field debris. Use the tie wraps provided.
Check to be sure the harnesses at center of machine
is slack enough so as not to be stretched or interfered
with while rotating frame from transport to field
working position and vice versa.
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
Do not attempt to lift heavy parts manually. Use
a hoist or a fork lift to move these parts into
position.