Landoll Bendi B40i4, Maintenance Manual

Page: 40 / 142

2-14 F-581-R1
PLANNED MAINTENANCE
.
Figure 2-18: Bearings, Race and Inner Seal
NOTE
If the bearings must be replaced, use a standard puller to
remove the inner and outer bearing cup (race) from the
wheel rim.
7. Wash the bearing in a solvent. Examine it for damage
or wear. Allow the parts to air dry.
8. Spin the bearings and check for unusual sounds
indicating rough surfaces (Brinelling) or
non-rotating
rollers.
9. Replace bearings if they are noisy or appear rough.
10. Pack the bearings with high-temperature bearing
grease making sure the grease penetrates the
rollers, cone and cage from the back side. See
page 1-17 for recommended lubricants.
11. Clean the spindle and examine it for wear or scoring
damage.
12. Install new bearing cup (race) by pressing into wheel
rim. Apply an even force to prevent cracking the cup
(race) during installation. Be sure that each bearing
cup (race) is fully seated (bottomed out) against the
shoulder in the rim bore.
13. Install the inner bearing cone into the wheel rim.
14. Carefully set the wheel over the grease seal and
spindle. Install the outer bearing cone, steel washer
and the spindle nut
.
15. While turning the wheel or rim counterclockwise,
apply 240 to 260 in. lbs. (27 to 29 Nm) of torque to
the spindle nut.
16. Spin the wheel to make sure it turns free, then back
off the wheel nut 1/2 turn.
17. While turning the wheel, apply 20 to 25 in. lbs. (2.26
to 2.82 Nm) of torque to the nut. Again, check to
make sure the wheel turns freely.
18. Back-off the nut slightly as necessary to align it with
the nearest hole. Insert and bend back the legs of the
new cotter pin.
19. Pump grease into the zerk on the inside of the
spindle until grease comes out of the bearing cone.
20. Install the hub cap.
Actuator Seal Lubrication
1. Start the forklift and turn the mast fully to the right.
2. Locate the two grease-fill ports on the front side of
the actuator (where mast is when in normal carry
position). See Figure 2-19.