Landoll Bendi B40i4, Maintenance Manual

Page: 13 / 142

INTRODUCTION, SAFETY AND INSPECTION
1-7
Maintenance Introduction
Preventative maintenance & inspections are an essential
part of all industrial equipment. A well planned inspection
program is essential to keeping the working environment
safe for the operator and for the longevity of the truck.
The inspection program designed by Landoll Corporation
periodically checks the integrity of Bendi forklift systems
such as:
• Checking performance of operator functions - lift, tilt,
side shift, attachment and traction systems.
• Checking for leaks.
• Checking fluid levels.
• Making sure components are securely attached.
• Checking the tires.
Regular and planned maintenance is the responsibility of
both the daily operator and the forklift technician.
To make sure these and other systems are checked
periodically, Landoll Corporation has developed a system
of checklists. A blank copy of each checklist can be found
on pages 1-8 through 1-14.
These checklists include:
• Operator’s Daily Checklist
• 1st 50 Hour Inspection Checklist
• 1st 300 Hour Inspection Checklist
• 300 Hour Inspection Checklist
• 600 Hour Inspection Checklist
• 2000 Hour Inspection Checklist
Except for the Operator’s Daily Checklist, these tasks are
usually performed by a service and maintenance facility
that is approved by Landoll Corporation. These
inspection sheets should be copied, completed and
maintained by the forklift technicians.
IMPORTANT
Recommended service inspections are based on
normal operating conditions. If the truck is subjected
to severe or above normal operating conditions,
extreme temperatures, excessive dust or wet
environments, or if the truck is around corrosive
materials, service must be performed at shorter
intervals.
Inspection Sheets
The following pages are OSHA (Occupational Safety and
Health Administration) required check sheets. These
sheets should be copied and the copies used for
maintenance checks on your Bendi Internal Combustion
lift. The pre-shift inspection on your IC forklift is an OSHA
requirement. It is the operator’s duty to inspect the lift
before each shift and report all problems to the person in
charge of forklift maintenance. Have a qualified mechanic
correct all noted problems.
Daily pre-shift inspection is an OSHA REQUIREMENT.
It’s important that these inspections are documented.