Landoll Bendi B40i4, Operator'S Manual

Page: 23 / 66

RECEIVING AND INSPECTION
2-5
Figure 2-3: Brake Release Pump/Valve Assembly
2. Close the manual valve by pulling upward on the
black handle, rotating 90°, then lowering until you feel
a click.
3. Push and release red manual hand pump
approximately 5 to 7 times to build enough pressure
to release the park brakes.
NOTE
The B40i4 forklift may be towed a maximum distance of
200 yards at a maximum of 2 mph.
4. To reset park brakes, open the manual valve by
pulling upward on the black handle, rotating another
90°, and lowering until you feel the detente cross pin
settle into place again.

WARNING
Shipping the Forklift
1. Set the mast to its forward position (straight ahead).
2. Back the truck onto its carrier so that the forks are
pointed away from the forward direction of motion.
3. Set the mast to its forward (level) position and lower
the forks to the bottom of the mast. Align the mast
indicator pointer located on each side of the mast to
a level position, as viewed from the front of the truck.
4. Set wedges against the front and rear tires and
fasten them to the floor of the carrier. If the carrier is
equipped with rings or receptacles for chains or cable
rope, support the truck as firmly as possible.
IMPORTANT
Do not run chain or wire directly touching any
finished metal surface. Use padding as necessary to
protect the truck finish from chains or cables.
Failure to reset park brakes will result in the
forklift having no brake function at all.