Landoll 9650 FC, Operator'S Manual, Page: 124 / 154

3-28 F-605-0221
ASSEMBLY INSTRUCTIONS
5 Row Spike Harrow Installation
See Figures 2-31 through 2-42 for 5 Row Spike Harrow
placement dimensions.
1. Attach spike harrow arm assemblies and spike
harrow arm clamp to rear frame using 3/4-10 x 9 hex
head cap screws and hex lock nuts
See Figure 3-20 .
NOTE
Location of bar clamps with tabs, and position
harrow arm assemblies in the correct locations.
2. Attach pull chain bracket to spike harrow arm clamp
using 3/4-10 x 5 hex head cap screws and hex lock
nuts.
3. Refer to Note: spike bar alignment See Figure 3-20
for proper alignment of spike bar assemblies. Be sure
they are aligned properly on both right and left side of
each section.
4. Attach spike bars to spike harrow arm assemblies
per placement drawings using bar clamps, bar clamp
plates 1/2-13 x 3 hex head cap screws, or bar clamps
w/ tabs, 1/2-13 x 1-1/4 hex head cap screws, and hex
lock nuts.
5. Refer to the “5 Row Spike Harrow Adjustments” in
Operation and Maintenance section for spike bar
alignment
See Figures 4-14 .
NOTE
See Figures 2-31 - 2-42 for 5 Row Spike Harrow
placement dimensions of spike harrow arms, spike bars,
and usage of bar clamps or bar clamps w/ tabs.
NOTE
The harrow arms with the catch tray hooks are used on
the outer wings with the catch tray hooks toward the
outside of the machine and the catch trays toward the
center of the machine
See Figures 2-31 through 2-42
and See Figure 3-20 for proper placement.