Landoll 345C, Operator'S Manual

Page: 33 / 64

4-3
NORMAL OPERATING SERVICE INTERVALS
a
SERVICE
INTERVAL :
ITEM
TIMES 1st 5
Hrs
Weekly Monthly 6
Months
Yearly
LUBE # NOTES
MILES 50 500 2,000 12,000 25,000
LIGHTS I I
WIRING & CONNECTIONS I I
FASTENERS I, T I b
PIVOT PIN, LIFT PINS AND LOCK
PINS
I I,L 3
WINCH CABLE ASSEMBLIES I I,L 4 g
BRAKE AIR SYSTEM I I I
ABS VALVES I, C
BRAKE ADJ & WEAR I I, T d
SLACK ADJUSTERS I I L 3 c
CAMSHAFT ASSYS I I L 3 c
HUB OIL I I, L R 5 c
WHEEL BEARINGS I I, T 5 c
TIRE INFLATION & WEAR I I e
WHEEL LUG NUTS I, T I I, T f
HYDRAULIC OIL I I R 1 c
HYDRAULIC FILTER R R
HOSES I I I
WINCH GEAR CASE I I 2 c
I – Inspect, R – Replace, T– Tighten/ Adjust Torque, L – Lubricate, C – Clean
NOTES:
a. Perform at the time shown. Shorten service intervals when operating in severe or dirty conditions.
b. See Tables 2-1 and 2-2 (Torque Specifications) for correct torque.
c. See Table 4-1 (Lube Specification Chart) for recommended lubricant.
d. Call Landoll Customer Services for procedures to replace.
e. See Serial Number Plate on the front of the trailer for proper inflation requirements.
f. See Figure 4-17, Stud Tightening Sequence .
g. Inspect prior to and after each use.
Table 4-2 Maintenance Schedule
(Inspect & Replace as needed) ,R