Landoll 317B, Operator'S Manual

Page: 42 / 80

4-4
NORMAL OPERATING SERVICE INTERVALS
a
SERVICE
INTERVAL :
ITEM
TIMES 1st 5
Hrs
Weekly Monthly 6
Months
Yearly
LUBE
#
NOTES
MILES 50 500 2,000 12,000 25,000
LIGHTS I I
WIRING & CONNECTIONS I I
FASTENERS I, T I b
KING PIN AND PLATE I C,I,L 3 c
BRAKE AIR SYSTEM I I I
RELAY VALVES I, C
BRAKE ADJ & WEAR I I, T d
SLACK ADJUSTERS I I L 3 c
CAMSHAFT ASSYS I I L 3 c
HUB OIL I I, L R 6 c
WHEEL BEARINGS I I, T 6 c,e
TIRE INFLATION & WEAR I I f
WHEEL LUG NUTS I, T I I, T b
SUSPENSION ALIGNMENT I I
UNDERCARRIAGE ROLLERS L 3 c
HYDRAULIC OIL I I R 1 c
HYDRAULIC FILTER R R
HOSES I I R
WINCH GEAR CASE I I 2 c
I – Inspect, R – Replace, T– Tighten/ Adjust Torque, L – Lubricate, C – Clean
NOTES:
a. Perform at the time shown. Shorten service intervals when operating in severe or dirty conditions.
b. See Tables 2-1 and 2-2 (General and Hydraulic Fitting Torque Charts) for correct torque.
c. See Table 4-1 (Lube Specification Chart) for recommended lubricant.
d. See Section 4-8 for procedures.
e. See Section 4-10 for procedures.
f. See Serial Number Plate on the front of the semitrailer for proper inflation requirements.
Table 4-2 317B Maintenance Schedule
(Inspect & Replace as needed)
I,