4-24
F-1044-0719
MAINTENANCE AND LUBRICATION
Figure 4-17: Mounting Tires and Wheels
Figure 4-18: Stud Tightening Sequence
INNER TIRE AND WHEEL
OUTER TIRE AND WHEEL
FLANGE NUT
HUB CAP
LOCKWASHER
CAP SCREW
GASKET
BRAKE DRUM
8
AND 10 STUD HUBS
Applles to M22 X 1.5 studs/two piece flange nut.
All threads are right hand metric.
First Tighten Flange Nuts to 50ft. lb. Using
sequence shown.
Check Disc-Wheel for proper
positioning on pads and proper seating
against flange.
Then Tighten Flange Nuts to recommended
torque using sequence shown.
3-573-010210
RECOMMENDED TORQUE: 450-500FT. LBS.
8
4
6
2
3
7
5
1
7
5
3
10
8
6
4
9
2
1
DANGER
Read and Understand the installation, service and safety instructions manual before installing or
servicing the hub. Failure to do so may result in personal injury or death, and may result in a
compromise of your vehicle’s safety through loss or failure of a wheel or compromise of the braking
system.
Use a torque wrench to assure proper torque, failure to do so will compromise your products service,
life and safety. Under torque and over torque can cause thread and/or nut damage, and may result in
the loss of a wheel.
Recheck torque after the first 50 to 100 miles of service. Parts may seat naturally, causing the torque
to drop. Proper torque is essential for the service, life and safety of this product.
