3-1
Chapter 3
Assembly Instructions
It is very important that your new 2512 Series Rigid or
Folding In-Row Ripper be properly assembled, adjusted,
and lubricated before use. Illustrations are provided in
this section to show proper assembly procedures.
Remove paint from grease fittings and replace any that
are damaged or missing. Be sure to return bolts, clips,
etc. to their original locations.
To ensure assemblies are aligned,
insert all bolts and
leave the nuts loose until completion of final
assembly
. Use lock washers or flat washers where
called for. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly
to prevent misalignment, distortion, or binding. Tighten all
bolts and nuts to the recommended torques shown on
. Tighten all U-bolt legs evenly.
IMPORTANT
Check all bolt lengths, nut sizes, etc., from the parts
book before assembly. Different models of the 2512
Series Rigid & Folding In-Row Ripper use different
size bolts.
Specific Dangers and Warnings
DANGER
DANGER
DANGER
WARNING
In the event a shank trips and does not release,
do not attempt to release the shank. Contact your
Landoll dealer for further instructions. A tripped
shank can release suddenly and cause serious
injury or death.
Coulter blades are extremely sharp. use extreme
care when working on or near coulter blades. Do
not allow coulters to roll over or fall on any part
of body. Do not allow wrenches to slip when
working near coulter blades. Never push
wrenches towards coulter blades. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges may result in
serious personal injury or death.
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the
system of all air may cause the machine to
operate improperly.
Summary of Contents for 2511 IN-3-30 2511 N-4-30 2511 N-5-30
Page 28: ...2 20 F 1040 0123 STANDARD SPECIFICATIONS TABLE OF CONTENTS NOTES...
Page 46: ...3 18 F 1040 0123 ASSEMBLY INSTRUCTIONS TABLE OF CONTENTS Table provided for general use NOTES...
Page 56: ...5 2 F 1040 0123 TROUBLESHOOTING GUIDE TABLE OF CONTENTS NOTES...
Page 58: ...6 2 F 1040 0123 QUICK START GUIDES TABLE OF CONTENTS Table provided for general use NOTES...