3-28
F-721-0513
ASSEMBLY INSTRUCTIONS
Figure 3-20: Light and SMV Bracket Installation (Prior to August, 2013)
Light Installation (Prior to
August, 2013)
NOTE
f
or light bracket placement. If
no dimension is given for a bracket, it should be located
against frame member as shown in drawing.
1.
Attach inner tail light mounting bracket supports to
the center frames using 1/2-13 x 8-1/2 hex head cap
screws, warning light bars, and hex lock nuts
2.
Connect enhanced lighting module to the right inner
tail light bracket using #8-32 x 1/2 slotted pan head
screws and hex nut.
3.
Attach outer lh and rh light brackets to frame
weldment using 1/2-13 x 5-1/2 hex head cap screws,
warning light bars, and hex lock nuts.
IMPORTANT
Outer light brackets need to be slid rearward as far
as possible. See Figures 2-1 thru 2-16 for light
bracket placement.
4.
Attach red brake lamps to inner tail light mounting
bracket supports and amber lamps to outer light
brackets using 1/4-20 x 1-1/4 and 1/4-20 x 1-1/2 hex
head cap screws and hex lock nuts.
5.
Connect warning light harnesses to lights.
6.
Attach SMV emblem and mounting bracket to rear
center frame bar using warning light bar, 1/2-13 x
5-1/2 hex head cap screws, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the rear bar of the frame.
7.
Attach red, orange, and yellow reflectors to outer rh
and lh tail light mounting brackets.
NOTE: IF REPAIRING OR REPLACING THE 7 PIN
CONNECTOR, MATCH THE LETTERS AT THE
BACK OF THE HARNESS TO THE 7 PIN CONNECTOR
AS SHOWN. THE COLOR OF THE WIRE JACKET
DOES NOT NECESSARILY MATCH THE COLOR
MARKING OF THE 7 PIN CONNECTOR.
4-PIN
CONNECTION
7-PIN
CONNECTION
C
A
B
D
BRN. 6
GRN. 5
YEL. 3
GRND. 1
WIRING CHART
#1 WHITE
#2 BLACK
#3 YELLOW
#6 BROWN
#5 GREEN
#4 RED
#7 BLUE
FACING 7-PIN CONNECTOR
