ASSEMBLING YOUR L&L EASY-FIRE KILN
easy-fire-install.pdf
3/1/2007 Rev 1.3
Page
2007
L&L Kiln Mfg, Inc. 505 Sharptown Rd, Swedesboro NJ 08085 P:856.294.0077 F:856.294.0070 [email protected] hotkilns.com
ASSEMBLING YOUR L&L EASY-FIRE KILN
Unpacking the kiln
1) With a screw driver pry off the staples holding the
bottom box tray to the box sleave .
2) Next remove the cardboard inset from the carton,
and remove the carton sleeve from the skid .
3) Push the foam tubes away from the kiln .
Removing foam tubes:
4) Carefully cut off the stretch wrap that is around
the kiln . Be careful not to scratch the kiln with your
knife .
Carefully cut off shrink wrap:
4) If you ordered a three section kiln, either the (e23T,
e28T) your kiln floor will be on top, remove it now .
If you ordered a two-section kiln, the floor of the kiln
will not be on the top, it will be on the bottom of the
kiln as it is part of the spring hinge mechanism which
is assembled but not engaged for shipping .
5) Notice that the spring on your spring hinge is not
engaged .
ASSEMBLING THE STAND
Next, using the stand hardware and vent system
hardware, assemble the vent system bypass collection
box to the kiln stand . Then the flexible duct to the
bypass collection box
1) Assembly the stand legs .
Make sure all the stand
legs are tight .
Use a nut driver or an adjustable
wrench to do this .
The legs get bolted to the stand with 1/4-20
bolts provided. They do not need nuts:
2) Attach the vent collection box (if you ordered the
vent) . If you did not order a vent then skip this .
The vent collection box fits over four studs on the
bottom of the stand and gets fastened on with
four 10-24 nuts :
