Gyr
Chapter 6 - Performing System Upgrades
Concentrator User and Installation Guide
98-1031 Rev AA
61
8.
Connect the AC power cable to the concentrator, and plug the other end into an outlet.
Loading the Concentrator Firmware Via Cables Using a Router
Hyperterminal automatically detects the concentrator. If it does not, close the Hyperterminal session,
unplug the concentrator, and start again.
1.
Assign the concentrator an IP address.
•
In Hyperterminal, specify the COM 1 port and properties as follows:
•
Bits per second:
9600
baud
•
Data bits:
8
•
Parity:
None
•
Stop bits:
1
•
Flow control:
None
.
Figure 6 - 7. Hyperterminal COM port and properties
