Repair Procedures
Elevation Potentiometer
84
Figure 7-17.
Elevation Nut Shaft Setting
16. Slide the two ¼” diameter pins through the elevation assembly and into the elevation nut. Secure the pins with
the two ¼-20 screws.
17. Calibrate the elevation potentiometer, See “Elevation Potentiometer Calibration” on page
7.16. Elevation Potentiometer
1. Remove the motor cover.
2. Remove the wires from the elevation potentiometer.
Figure 7-18.
Elevation Potentiometer
3. Remove the retaining nut and slide the potentiometer from its bracket.
4. Re-installation is the reverse of removal. Reconnect the potentiometer as shown in “Interconnect Wiring Dia
gram - LTD and Home Models, ESI PWM Control PCB” on page
19 or “Interconnect Wiring Diagram - Club
21 depending on the model.
Elevation
Potentiometer
Bracket
Retaining Nut
Summary of Contents for L7 Club
