Land Pride RTR12 Series, Operator'S Manual

Page: 36 / 44

Section 4: Maintenance and Lubrication
Table of Contents
RTR12 & RTA12 Series (Serial No. ) Rotary Tillers 311-883M 11/19/19
32
Chaincase
Type of Lubrication:
Shell Gadus S2 V220 00 flowable grease
Land Pride #821-045C (32oz. bottle)
Quantity: Gear Lube will run out of lower plug when full.
IMPORTANT:
Tiller should be level when checking
oil level in chaincase. Check oil level by removing
lower level plug. Oil should reach bottom of plug
hole. Remove fill plug and add recommended
lubrication as needed. Tighten both plugs when
done.
Gearbox
Check oil every 50 hours of operation by removing center
level plug at the rear of the gearbox, oil should come to
bottom of center plug hole. Add recommended gear lube
through fill plug hole until oil begins to flow out of oil level
plug hole. DO NOT OVERFILL!
Tighten all plugs when done.
Type of Lubrication: SAE 80-90W EP Oil
Quantity = Fill until oil begins to flow out of oil level plug
hole.
50
Hours
As
Required
Bearing On Right End Of Rotor Shaft
Type of Lubrication: Multi-Purpose
Quantity = As Required
30356
RTA Series RTR Series
30364 30357
Level Plug
Level Plug
Fill Plug
Fill Plug
30358
8
Hours