Section 2: Set-Up of Options
RBT4084, RBT4096 & RBT40108 Rear Blades 301-206M
11/27/18
13
Blade Angle Manual Link
Refer to Figure 2-4:
Kit Bundles
300-182A. . . . . . MANANUAL ANGLE LINK ASSEMBLY
300-182A. . . . . MANANUAL OFFSET LINK ASSEMBLY
890-637C . . . . . . . . . . . RATCHET JACK 16.25 - 22.25
The manual links and ratchet jack may be used in place
of the hydraulic cylinders.
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1.
Attach manual angling links (#3 & #4) to the right side
of the Rear Blade as shown with two 1" clevis pins
(#1). Secure with hair pin cotters (#2).
2. Adjust blade angle by removing hitch pin (#5) and
moving link (#3) to a different hole. Replace hitch pin
and secure with hair pin cotter (#6).
Manual Offset, Angle Link and Blade Tilt
Figure 2-4
25536
FRAME OFFSET
MANUAL LINK
BLADE ANGLING
MANUAL LINK
BLADE TILTING
RATCHET JACK
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Blade Offset Manual Link
Refer to Figure 2-4:
1.
Attach manual offset links (#9 & #10) to the right side
of the Rear Blade as shown with two 1" clevis pins
(#7). Secure with hair pin cotters (#8).
2. Adjust frame offset by removing hitch pin (#11) and
moving link (#9) to a different hole. Replace hitch pin
and secure with hair pin cotter (#12).
Blade Tilt Ratchet Jack
Refer to Figure 2-4:
1.
Attach ratchet jack (#13) to the back side of the Rear
Blade as shown with two 1" clevis pins (#14). Secure
with hair pin cotters (#15).
2. Adjust blade tilt by setting the lock on the ratchet
lever and pumping the lever back and forth to raise
one end of the blade higher than the other end.
Reposition ratchet lock and pump lever back and
forth to tilt blade in the opposite direction.
3. Remove shipping block after ratchet jack (#13) has
been installed.
