Land Pride RCP2660, Operator'S Manual

Page: 60 / 74

Section 8: Maintenance & Lubrication
Table of Contents
11/2/18 RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
56
Wing Skid shoe
Figure 8-3
Skid Shoes
WARNING
!
To avoid serious injury or death:
Excessive wear on skid shoes can damage side panels, cause
inadequate operation of cutter, and create a safety hazard.
Always replace skid shoes at the first sign of wearing thin.
Inspect skid shoes at the beginning of each cutting
season. Check all skid shoes weekly for wear and
replace if necessary. Original material thickness is 1/4".
They should be replaced when the material thickness is
less than 1/8" at any point. They are interchangeable
from left to right.
Order only genuine Land Pride parts from your local Land
Pride dealer.
Refer to Figure 8-3:
Replace wing skid shoes as follows:
1. Remove 3/8" hex whiz nuts (#3), 3/8" plow bolts (#2),
and skid shoe (#1) as shown.
2. Plow bolts should be checked for wear and replaced
if necessary.
3. Attach new skid shoe (#1) to cutter with existing
3/8" plow bolts (#2) and secure with 3/8" hex whiz
nuts. Torque to 31 ft. lbs.
4. Repeat on opposite side.
24623
Land Pride Skid Shoe Replacement Parts
Part No. Part Description
312-602D SKID SHOE
802-603C PLOW BOLT, 3/8" - 16 x 1" grade 5
Solenoid Valve Block
Figure 8-4
Solenoid Valve Block
Refer to Figure 8-4:
The 1/2" hex nut on the end of the solenoid armature
shaft must be removed to remove a solenoid valve from
the valve block. Use care when removing and replacing
this nut. Do not tighten nut with more than 3 ft. lbs. of
torque.
See your nearest Land Pride dealer to purchase new
solenoid vales and/or seal kits.
24628
IMPORTANT: Do not exert more than 3 ft. lbs. of
torque on the hex nut securing the solenoid
armature. Remember, 3 ft. lbs. is slightly more
than finger tight! Over tightening this nut will
distort hollow armature shaft and may result in
valve break down.