Land Pride PR1048, Operator'S Manual, Page: 17 / 40

Section 1: Assembly & Set-Up
Table of Contents
6/19/23 PR1048 & PR1060 Powered Rakes 314-299M
13
Connect Powered Rake
Refer to Figure 1-2:
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while connecting and disconnecting
the implement. Keep people and animals away while backing-
up to the implement or pulling away from the implement. Do
not operate hydraulic controls while a person or animal is
directly behind the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
•
Lightweight tractors with rear attached implements may
need weights added to the front to maintain steering control.
Consult your tractor Operator’s Manual to determine
weight requirements and maximum limitations.
•
Always shut tractor down according to “Tractor Shutdown
Procedure” provided in this manual before allowing
anyone, including the operator, to connect or disconnect the
implement.
IMPORTANT: The tractor’s lower 3-point arms must
be stabilized to prevent side-to-side movement.
Most tractors have sway blocks or adjustable chains
for this purpose.
NOTE: Land Pride’s Quick Hitch can be attached to
the tractor to provide quick and easy 3-point connect
and disconnect. See your nearest Land Pride dealer
to purchase a Quick-Hitch.
The PR10 Series Powered Rakes require a 3-point Cat. l
hitch. The lower 3-point arms must be stabilized to
prevent side-to-side movement. Most tractors have sway
blocks or adjustable chains for this purpose.
A top Quick Hitch bushing is mounted in the lower holes
on the center clevis as shown for connecting to a Quick
Hitch. The upper holes on the center clevis are for
standard 3-point connection using customer supplied
hitch pin and hitch pin keeper.
1. Remove linch pins (#1) from lower hitch pins (#2) and
set aside.
2. Slowly back tractor to the Powered Rake while using
tractor’s 3-point hydraulic control lever to align
3-point lift arms with lower hitch pins (#2) on Powered
Rake.
3. Shut down tractor according to
“Tractor Shutdown
Procedure” on page 11.
4. Attach 3-point lift arms to lower hitch pins (#2) and
secure with linchpins (#1).
5. Connect center 3-point link to upper clevis holes with
hitch pin and hitch pin keeper. Hitch pin and keeper
are supplied by customer.
6. Move stand (#5) to operating position. Refer to
“Stand Adjustments”
on page 22 if needed.
NOTE:
Customer to supply center 3-point hitch pin
and hitch pin keeper.
Connect Powered Rake (Shown with Optional Hydraulic Angle Kit)
Figure 1-2
Center
3-Point Link
3-Point
Lift Arms
Power
Take-off Shaft
Drawbar
78833 37298
Customer supplied center 3-point hitch pin & keeper pin
Quick Hitch bushing