Section 5: Maintenance
9/25/18
GS2572, GS2584 & GS2596 Grading Scrapers 303-268M
15
Skid Shoe Maintenance
Figure 5-2
Skid Shoes
Skid shoes should be inspected at the beginning of each
season and replaced when material thickness is less
than 1/8" at any point. The skid shoe may be turned
around to extend its wear life if one end is wearing faster
than the other.
Order only genuine Land Pride parts from your local Land
Pride dealer when replacing skid shoe components.
Replace or turn skid shoe around as follows:
Refer to Figure 5-2:
1.
Raise Grading Scraper 3" or more off the ground and
place support blocks under the scraper. Make sure
support blocks are positioned so they will not
interfere with skid shoe replacement.
2. Lower scraper onto support blocks, place tractor in
park, set park brakes, shut tractor engine off and
remove switch key.
3. Remove 3/8" hex flange locknuts (#3), 3/8"-16
plow
bolts (#1), and skid shoe (#2) from scraper.
4. Plow bolts should be checked for wear and replaced
if necessary.
5. Turn old skid shoe around or install new skid shoe to
scraper with 3/8"
-16 x 1" GR5
plow bolts (#1) and
3/8" hex flange locknuts (#3). Tighten locknuts (#4) to
the correct torque.
6. Raise scraper up and remove support blocks.
26657
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help ensure the unit is ready
for field use the next time you hook-up to it.
1.
Clean off any dirt and grease that may have
accumulated on the scraper. Scrape off compacted
dirt from the bottom of frame and then wash surface
thoroughly with a garden hose. A coating of oil may
also be applied to the lower frame area to minimize
oxidation.
2. Inspect Grading Scraper for loose, damaged, or
worn parts and adjust or replace as needed.
Repaint parts where paint is worn or scratched to prevent
rust. Ask your Land Pride dealer for aerosol touch-up
paint. They are also available in touch-up bottles with
brush, quarts, and gallon sizes by adding TU, QT, or GL
to the end of the aerosol part number.
3. Replace all damaged or missing decals.
4. Store scraper on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer scraper life.
Ordering Replacement Parts
Land Pride offers equipment in factory standard Beige
with black highlights. This implement is also available in
Orange.
When ordering an optional color, the suffix number
corresponding to the color must be added at the end of
the part number. Parts ordered without the suffix number
will be supplied in factory standard colors.
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is orange,
then add the suffix 82 to the end of the number to make
the part number read 555-555C82.
Land Pride Touch-up Paint
Part No.
Part Description
821-011C
PAINT LP BEIGE SPRAY CAN
821-066C
PAINT ORANGE SPRAY CAN
821-070C
PAINT GP GLOSS BLACK SPRAY CAN
82 . . . . . . . Orange
85 . . . . . . . Black
