Land Pride CB0550, Operator'S Manual

Page: 11 / 28

Section 1: Assembly & Set-up
CB0550 4-in-1 Combination Bucket 381-139M 2/5/19
7
Table of Contents
Section 1: Assembly & Set-up
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1. Reduce engine speed and shut-off all power to the
attachment.
2. Park tractor and attachment on solid, level ground.
3. Lower attachment until it is flat on the ground or on
non-concrete support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7. Use steps, grab-handles and anti-slip surfaces when
stepping getting on and off the tractor.
Assembly Checklist

Check Ref.
Have a hoist, fork lift or loader with properly sized chains and
safety stands capable of lifting and supporting the equipment
on hand.
Have a minimum of two people available during assembly.
Make sure all major components and loose
parts are shipped with the machine.
Operator’s
Manual
381-139M
Double check to make sure all parts, fasteners
and pins are installed in the correct location to
lessen the chance of using a bolt incorrectly,
Refer to the Parts Manual if unsure.
Parts Manual
381-139P
Make sure working parts move freely, bolts are
tight & cotter pins are spread.
Operator’s
Manual
381-139M
Make sure all safety labels are correctly
located and legible. Replace if damaged.
Page 4
Tractor Requirements
The CB0550 bucket is designed exclusively for attaching
to Kubota BX tractors with a front loader.
Kubota Tractor:
60 & 70 Series BX Tractors With a Front Loader
Hitch Requirement:
Kubota’s Original Quick Hitch Option No. BX6315
or Land Pride’s Extended Hitch Pin Option,
Part No. 380-146A
Hydraulic Outlets:
Land Pride’s Third Function Valve Accessory Kit,
Part No. 380-137A
Tractor Weight:
See Warning Note Below
WARNING
!
To avoid serious injury or death:
•
Consult your power machine’s manual for operating
capacity, lifting capacity, and operating specifications.
Exceeding rated capacities and specifications can result in
a roll-over or other serious hazard.
•
Lightweight tractors with rear attached implements may
need weights added to the front to maintain steering control.
Consult your tractor Operator’s Manual to determine
proper weight requirements and maximum weight
limitations.
Before You Start
WARNING
!
To avoid serious injury or death:
Allow only persons to operate this implement who have fully
read and comprehended this manual, who have been properly
trained in the safe operation of this implement, and who are
age 16 or older. Serious injury or death can result from the
inability to read, understand, and follow instructions provided
in this manual.
Read and understand the operator’s manual for your
bucket. An understanding of how it works will aid in
assembly and setup of your bucket.
It is best to go through the Assembly Checklist below
before assembling the bucket. Speed up your assembly
task and make the job safer by having all needed parts
and equipment readily at hand.
Torque Requirements
See “Torque Values Chart” page 22 to determine
correct torque values when tightening hardware.