LANCOM WLC
-
4006 - LANCOM WLC
-
4025
Chapter 4: Configuring the WLAN Controller
49
EN
4.2
Extended settings
Most of the parameters for configuring the LANCOM WLAN Controller corre-
spond with those of the Access Points. For this reason, this documentation
does not explicitly describe all of the WLAN parameters, but only those
aspects necessary for operating the WLAN Controller. Information on the
available WLAN parameters can be found in the LCOS reference manual.
4.2.1
General settings
This area is for the basic settings of your WLAN Controller.
Automatically accept new APs (Auto-accept)
Enables the WLAN Controller to provide all new Access Points with a
configuration, even those not in possession of a valid certificate.
Enables the WLAN Controller to provide a certificate to all new Access
Points
without
a valid certificate. One of these two conditions must be
fulfilled for this:
A configuration is entered into the AP table for the Access Point under
its MAC address.
The option 'Automatically provide APs with the default configuration'
is activated.
Automatic provision of the default configuration
This enables the WLAN Controller to assign a default configuration to
every new Access Point (even those
without
a valid certificate), even if no
explicit configuration has been stored for it. In combination with auto-