LANCOM WLC
-
4006 - LANCOM WLC
-
4025
Chapter 2: Installation
30
EN
햳
Further network devices
– you can optionally connect further network
devices to the LAN interfaces
쐃
.
The LAN connectors use autosensing to recognize the data rate (10/100
Mbit) and the type (node/hub) of attached network devices. It is possible
to connect devices of different speeds and types in parallel.
햴
Configuration interface
– optionally, the router can be connected
directly to the serial interface (RS-232, V.24) of a PC. Use the connection
cable supplied for this. Connect the LANCOM configuration interface
쐋
to an available serial interface on the PC.
햵
Power supply
– the socket
쐄
is for connecting the supplied power sup-
ply unit.
With the LANCOM WLC-4006 use only the supplied power adapter!
The use of the wrong power adapter can be of danger to the device
or persons.
햶
Supply power and switch on
– Using the IEC cable, supply power to the
device and switch it on using the switch
쐂
.
햷
Installation complete
– This step completes the installation of the hard-
ware. The next steps are to install the management software and to con-
figure the LANCOM WLAN Controller.
2.4
Software installation
The following section describes the installation of the Windows-compatible
system software LANtools, as supplied.
You may skip this section if you use your LANCOM Router exclusively
with computers running operating systems other than Windows.
2.4.1
Starting Software Setup
Place the product CD into your drive. The setup program will start automati-
cally.
If the setup does not start automatically, run AUTORUN.EXE in the
root directory of the product CD.